Download PSD813F1/80C31 Design Tutorial Application Note 057

Transcript
After the Flash has been programmed and/or validated, the Flash memory is moved from 8031
data space to 8031 program space by the MCU writing 06h to the VM register (while still
executing out of PSD EEPROM).
Figure F2 represents the memory map after the Flash has been moved to program space. This is
an intermediate step that is a result of writing to the VM register.
Next, 8031 execution jumps from PSD EEPROM to PSD Flash. While executing from PSD
Flash, the 8031 will set a bit in the PSD page register that we call “SWAP”. Note: if the
“SWAP” bit was set while executing from EEPROM, indeterminite results would occur. (It’s
like pulling a rug out from under yourself.) Now, the EEPROM that the MCU booted from
during power-up is replaced with Flash memory that contains application vectors and code, as
shown in Figure F3. The transition between the two maps of Figures F2 and F3 is under control
of the 8031 by setting the "SWAP" bit inside the PSD (defined in the PSDabel (tutor8xx.abl)
file). Again, the state of the memory map shown in Figure F3 is an intermediate step.
NOTE: Individual bits within the 8-bit PSD page register may be used for functions other
than memory page definition. For example, in this tutorial, two of the eight PSD page
register bits are use to define four memory pages, and one of the page register bits is used
as the “SWAP” bit, described above.
Finally, while executing from PSD Flash memory, the 8031 must write 0Ch to the VM register in
the PSD to move the PSD EEPROM from 8031 program space to 8031 data space. At this point,
the MCU may jump to the new reset vector that resides at location 0000h in Flash segment FS0.
This will finalize the memory map, as shown in Figure F4. Now, all 128 Kbytes of PSD Flash
memory are in program space, with 32 Kbytes in a common area and 96 Kbytes spread across
three memory pages. Also, the EEPROM is now in data space and is accessible from any
memory page. Notice that two PSD EEPROM segments (EES2 and EES3) appear in Figure F4.
These two segments are for general data use while the other two EEPROM segments (EES0 and
EES1) comprise the 8031 power-on boot code.
Now that the system memory map looks like that of Figure F4, another feature becomes
available. Besides the mechanisms mentioned, there is one more memory mapping control bit
used in this tutorial design. This bit, “ENABLE_DATA_HALF”, is another PSD page register
bit used to protect the boot code in EES0 and EES1 from inadvertent writes. At the same time, it
enables the other half of EEPROM (EES2 and EES3) to be accessed for general data. For
example, to update the boot code in EES0 and EES1 with new code downloaded over the UART,
the 8031 would leave ENABLE_DATA_HALF at logic zero, perform the update by writing to
EES0 and EES1, then set ENABLE_DATA_HALF to logic one. Now the new boot code is
inaccessible (protected while not booting), and the data half of EEPROM is accessible.
WSI Inc. - Fremont CA - 800-832-6974 -
waferscale.com
69