Download EVB9S12NE64

Transcript
E V B 9 S 1 2 N E 6 4
0 5 / 2 4 / 0 4
TROUBLESHOOTING
The EVB9S12NE64 is fully tested and operational before shipping. If it fails to function
properly, inspect the board for obvious physical damage first. Verify the communications setup
as described under GETTING STARTED.
The most common problems are improperly configured communications parameters, and
attempting to use the wrong COM port.
1. Verify that your communications port is working by substituting a known good serial device
or by doing a loop back diagnostic.
2. Verify the power source, ON/OFF switch is ON, Indicators are ON? You should measure a
minimum of 9 volts between the GND and +VIN connections on the TB1 power connector
with the standard power supply provided.
3. Disconnect all external connections to the board except for COM1 to the PC and the wall
plug power supply.
4. If no power indications, verify the fuse FZ1 is not open. If the +VIN supply is good and the
fuse is ok, immediately disconnect power from the board. Contact [email protected]
by email for instructions and provide board name and problem.
5. Make sure that the RESET line is not being held low or the RESET indicator is not lit.
6.
Contact [email protected] by email for further assistance. Provide board name and
describe problem.
19