Download 6vx7 user`s manual
Transcript
6VX7 USER'S MANUAL 1. System power on by PS/2 Mouse: First, enable this function in CMOS Setup, then you can power on the system by double clicking the right or left button of your PS/2 Mouse. 2. System power on by Keyboard: If your ATX power supply supports larger than 300 mA 5V Stand-By current (depends on the specification of keyboards), you can power on your system by entering password from the Keyboard after setting the “Keyboard power on” jumper and password in CMOS Setup. 3. Support 3 steps ACPI LED selectable. 4. Support Modem Ring-On. (Include internal Modem and external modem on COM A and COM B) 5. Support Wake-up On LAN. (Your ATX power supply must support larger than 720 mA 5V Stand-By current) * JP13 & JP14 Jumper (PCB Ver:1.3 and after use), please reference page 18. CeleronTM Socket 370 Processor MAINBOARD REV. 1.3 First Edition R-13-01-090520 6VX7 The author assumes no responsibility for any errors or omissions which may appear in this document nor does it make a commitment to update the information contained herein. Third-party brands and names are the property of their respective owners. Sound Blaster is a registered trademark of Creative Technology Ltd in the United States and certain other countries. Sound Blaster-LINK and SB-LINK are trademarks of Creative Technology Ltd. May 20, 1999 Taipei, Taiwan 1 Quick Installation Guide I. Quick Installation Guide : The system bus speed can be set for 66MHz. The user can select the system bus speed (SW2) and change the DIP SWITCH (SW1) selection to set up the CPU speed for 366 - 566MHz processor. M The CPU speed must match with the frequency RATIO. It will cause system hanging up if the frequency RATIO is higher than CPU's. SW1: (O:ON / X:OFF) DIP SWITCH (SW) FREQ. RATIO 1 2 3 4 X3 O X O O X 3.5 X X O O X4 O O X O X 4.5 X O X O X5 O X X O X 5.5 X X X O X6 O O O X X 6.5 X O O X X7 O X O X X 7.5 X X O X X8 O O X X X 8.5 X O X X X9 O X X X X 9.5 X X X X 2 6VX7 Set System Bus Speed SW2: (O:ON / X:OFF) CPU AGP 1 2 3 4 66 66 O X X O 75 75 O O X O 83 83 O X O O 100 66 X X X X 112 75 X O X X 133 89 X X O X « Note: We don’ t recommend you to set up your system speed to 75,83,100,112 or 133MHz because these frequencies are not the standard specifications for CPU, Chipset and most of the peripherals. Whether your system can run under 75,83,100,112 or 133MHz properly will depend on your hardware configurations: CPU, SDRAM, Cards, etc. + The black part in the picture is the white extruding piece of the DIP switch. 1. CeleronTM 366/ 66 MHz FSB OFF ON 1 2 CPU OFF ON 1 2 SW 2 3 SW 1 4 3 4 SW2 VT82C693 SW1 VT82C 596A 6VX7 3 Quick Installation Guide 2. CeleronTM 400/ 66 MHz FSB OFF ON OFF ON 1 1 2 2 3 3 4 4 SW2 SW1 3. CeleronTM 433/ 66 MHz FSB OFF ON OFF ON 1 1 2 2 3 3 4 4 SW2 SW1 4. CeleronTM 466/ 66 MHz FSB OFF ON OFF ON 1 1 2 2 3 3 4 4 SW1 SW2 4 6VX7 5. CeleronTM 500/ 66 MHz FSB OFF ON OFF ON 1 1 2 2 3 3 4 4 SW2 SW1 6. CeleronTM 533/ 66 MHz FSB OFF ON OFF ON 1 1 2 2 3 3 4 4 SW2 SW1 7. CeleronTM 566/ 66 MHz FSB OFF ON OFF ON 1 1 2 2 3 3 4 4 SW1 SW2 5 Quick Installation Guide II. Jumper setting : SPK : Speaker Connector CPU External Speaker + 1 SW1 VT82C PIIX4 596A PIN No. Function 1 VCC SW2 VT82C693 2 82443BXNC 3 NC 4 Data 6VX7 Buzzer RST : Reset Switch CPU PIN No. Function Open Normal Operation Close ResetVT82C693 Hardware 82443BX SW1 System VT82C PIIX4 596A 6VX7 6 SW2 6VX7 PW LED : Power LED Connector CPU + − − VT82C PIIX4 596A PIN No. SW11 2 3 6VX7 Function VT82C693 82443BX LED + LED − LED − SW2 HD : IDE Hard Disk Active LED CPU SW2 + VT82C PIIX4 596A − VT82C693 82443BX PIN No. Function 1 LED + 2 LED − SW1 6VX7 7 Quick Installation Guide GN : Green Function Switch CPU VT82C PIIX4 596A PIN No. FunctionVT82C693 82443BX Open Normal Operation SW1 Close Entering Green Mode SW2 6VX7 GD : Green LED CPU SW2 − VT82C PIIX4 596A + PIN SW1 No. Function 1 LED + 2 LED − 6VX7 8 VT82C693 82443BX 6VX7 IR : Infrared Connector (Optional) 1 PIN No. 1 2 3 4VT82C PIIX4 596A 5 + CPU Function IR data output GND SW1input IR data NC Power(+) SW2 VT82C693 82443BX 6VX7 Soft POWER : Soft Power Connector CPU VT82C PIIX4 596A PIN No. Function 1 SW1 Signal 2 GND 6VX7 9 SW2 VT82C693 82443BX Quick Installation Guide ATX POWER : ATX Power Connector 1 11 VT82C PIIX4 596A Pin No. 3,5,7,13, 15-17 1,2,11 4,6,19,20 10 SW1 12 18 8 6VX7 9 14 Function GND CPU 3.3V VCC VT82C693 82443BX +12V -12V -5V Power Good 5V SB stand by+5V PS-ON(Soft On/Off) SW2 PS/2 Mouse / Keyboard Connector PS/2 Mouse SW1 VT82C PIIX4 596A PS/2 Keyboard CPU PS/2 Mouse/ Keyboard Pin No. Function 1 Data SW2 2 NC VT82C693 82443BX 3 GND 4 VCC(+5V) 5 Clock 6 NC 6VX7 10 6VX7 CPU FAN : CPU FAN Connector 1 PIN No. 1 2 3 Function CPU GND +12V SENSE SW2 VT82C693 82443BX SW1 VT82C PIIX4 596A 6VX7 PWR FAN : Power FAN Connector 1 CPU PIN No. Function 1 GND 2 +12V 3 VT82C693 SENSE 82443BX SW1 VT82C PIIX4 596A 6VX7 11 SW2 Quick Installation Guide SYSTEM FAN : System FAN Connector CPU 1 PIN No. Function 1 SW1 GND VT82C 2 +12V PIIX4 596A 3 SENSE SW2 VT82C693 82443BX 6VX7 IDE1: For Primary IDE port CPU SW2 VT82C693 82443BX SW1 VT82C PIIX4 596A 6VX7 1 12 6VX7 IDE2: For Secondary IDE port CPU SW2 VT82C693 82443BX SW1 VT82C PIIX4 596A 6VX7 1 FLOPPY : FLOPPY PORT CPU SW2 VT82C693 82443BX SW1 VT82C PIIX4 596A 6VX7 1 13 Quick Installation Guide LPT PORT / COM A / COM B LPT PORT CPU SW2 VT82C693 82443BX COM B SW1 COM A VT82C PIIX4 596A 6VX7 JP1 : Keyboard Power On Selection PIN No. 1-2 close 2-3 close 3 2 1 Function Keyboard Power on CPU Enabled Keyboard Power on Disabled (Default) VT82C693 82443BX SW1 VT82C PIIX4 596A 6VX7 14 SW2 6VX7 USB : USB Port SW1 PIN No. 1 2 3 4 5 6 7 8 Function USB V0 USB D0-CPU USB D0+ GND USB V1 USB D1USB D1+ VT82C693 82443BX GND SW2 VT82C PIIX4 596A 6VX7 JP7: Wake On LAN CPU SW2 1 2 3 VT82C PIIX4 596A PIN No. SW1 1 2 3 6VX7 Function +5V GND Signal 15 VT82C693 82443BX Quick Installation Guide JP9 : CLEAR CMOS FUNCTION 3 2 1 CPU PIN No. Function 1-2 close Clear CMOS SW1 2-3 close Normal (Default) VT82C SW2 VT82C693 82443BX PIIX4 596A 6VX7 J14 :SB-LINK PIN No. CPU 1 2 3 1 4 VT82C693 82443BX5 6 SW1 VT82C PIIX4 596A 6VX7 16 Function Signal GND NC Signal SW2 GND Signal 6VX7 J16: Internal Modem Ring On CPU 1 PIN No. 1 VT82C 2 Function Signal SW1 GND SW2 VT82C693 82443BX PIIX4 596A 6VX7 JP10 : CASE OPEN (Optional) CPU 1 PIN No. Function VT82C693 1 Signal 82443BX SW1 2 GND VT82C PIIX4 596A 6VX7 17 SW2 Quick Installation Guide JP12 :Buzzer Enable CPU PIN No. Function Open Internal Buzzer Disable SW1 Close Internal Buzzer Enable VT82C PIIX4 SW2 VT82C693 82443BX 596A 6VX7 JP13 / JP14 (PCB 1.3 and after version use) JP13 CPU JP14 Open Short 82443BX PIN No. Function VT82C693 SW1 Open Normal (Default) VT82C PIIX4 596A Short Close for Voodoo III 6VX7 VGA Card 18 SW2 6VX7 BAT1 :Battery MDanger of explosion if battery is incorrectly replaced. CPU MReplace only with the same or equivalent type recommended by the manufacturer. SW2 VT82C693 82443BX MDispose of used batteries according SW1 to the manufacturer’s instructions. VT82C PIIX4 596A + 6VX7 III. Top Performance Test Setting: Users have to modify the value for each item in chipset features as follow for top performance setting. ** Each value of items as above depends on your hardware configuration : CPU , SDRAM , Cards , etc. Please modify each value of items If your system does not work properly . 19 Quick Installation Guide The following performance data list is the testing results of some popular benchmark testing programs. These data are just referred by users, and there is no responsibility for different testing data values gotten by users. (Different Hardware & Software configuration will result in different benchmark testing results.) • CPU Intel CeleronTM 366MHz Socket 370 processor • DRAM (128x 1) MB SDRAM (SEC KM48S8030BT-GH801) • CACHE SIZE 128 KB included in CPU • DISPLAY GA-630 AGP Display Card (16MB SGRAM) • STORAGE Onboard IDE (Seagate ST34520A 7200RPM) • O.S. Windows NT ™4.0 (SP4) • DRIVER Display Driver at 1024 x 768 x 64k colors x 75Hz. VIA Bus Master IDE Drivers Processor Intel CeleronTM (Scoket 370) 366MHz (66x5.5) 433MHz (66x6.5) CPU mark32 588 631 FPU Winmark32 1970 2320 Business Disk 4100 4160 Hi-End Disk 10300 10200 Business Graphics 156 172 Hi-End Graphics 307 358 Business 24.5 26 Hi-End 21.6 23.4 Winbench99 Winstone99 20