Download WaveGuide - Water Level User Manual

2.2
WaveGuide server
For ease of use, the connector poles common between the WaveGuide server and radar are
marked using the same labeling symbols.
Figure 2.2: Connector panel on the WaveGuide server.
In addition to the connectors used for connecting the WaveGuide radar, the connector panel
of the WaveGuide server includes the following connectors,
• COM1: Reserved service port.
• COM2: Serial port for data output via a RS-232 connection.
• COM3: Serial port for data output via a RS-232 connection.
• LAN port: Ethernet access to the server.
Note
Each COM port is connected in parallel to both the DE-9 connector and the terminal
block connector. Hence, only one of the two types of connectors needs to be used per
COM port.
When the radar is powered through the server, then the power supply for the server must
be 24-36 [VDC]. Please do take care of the voltage drop due to wire resistance between the
server and the radar. The power supply to the WaveGuide radar is controlled by the power
switch on the WaveGuide server.
7