Download Total Eclipse Manual

TOTAL ECLIPSE Installation
TOTAL ECLIPSE Controller Mounting
1 Attach Velcro-style Strips
The TOTAL ECLIPSE controller may be mounted either horizontally
(such as on top of the washer) or vertically (such as on the front of
the washer). Mount the unit using the self-adhesive strips provided.
For added security, you may use nuts and allen bolts or other fasteners
(provided) as is appropriate to the mounting surface (Figure 4).
2 (Opt
Ins
Scr
Nu
1.Position the controller for easy access to the keypad and
3 With J1 and J2 cables
display screen.
Connectslide
cables
connected,
before
sliding
2.Mark a mounting location that is on, or close to, the washer. Controller front onto
front onto
mounting
bracket until it snaps into place.
Surface must be clean and dry.
bracket.
3.Join the four velcro-style strips firmly together to form two pair.
Mounti
4.Peel backing from one strip of each pair and place, adhesive-side down, in each recess on the mounting bracket. Press firmly for Velcro-style Strips and
Mounting Bracket
good adhesion.
5. Peel backing from opposite strips and press mounting bracket Optional Wall Board Screws,
Masonry Nuts, Allen Bolts
onto smooth, clean surface (use alcohol wipe, if needed)
at marked location.
6. With cables connected, slide controller front down onto mounting Figure 4 TOTAL ECLIPSE Controller
bracket (controller back), guiding cables into slots and pressing Mechanical Installation
down firmly until front and back snap into place.
Set Operating Language, Date & Time on Start-Up
After all electrical, plumbing, and mechanical installation is complete, apply
power to the TOTAL ECLIPSE Controller. At the first power up, the LANGUAGE
menu follows the splash screen to allow menu language selection.
Choose one of the operating menu languages that are pre-installed in
each controller (English or Spanish [Americas]; English or German [EU])
or download additional TOTAL ECLIPSE Controller operating menu
language files from the Hydro Systems website
(www.HydroSystemsCo.com) to a USB flash drive. Installing a language
from a USB flash drive to a controller replaces the non-English menu
language in the controller (English remains permanently installed).
Select Language
LANGUAGE
ENGLISH
SPANISH
Default N. America Controller
LANGUAGE
ENGLISH
SPANISH
FRANCAIS
DEUTSCH
SVENSKA
PORTUGUESE
STEP 1: Select Operating Language
a. Move the selection box, using the UP or DOWN ARROW KEYS,
until it frames your chosen language. (Optional) To replace the
non-English language with a different language, connect a USB flash
drive containing the downloaded languages to USB port “A” (the
USB Flash Drive with Additional
lower USB port on the controller’s right side). Available languages
Languages Connected
appear for selection. (Default N. America Controller)
b.
Press the ENTER KEY to select the operating language and
launch the DATE & TIME menu.
Change Language After First Power Up
a. Shut off power to TOTAL ECLIPSE by unplugging J1 cable or shutting off pumpstand power switch. Settings and data are retained.
b. Connect a USB flash drive and restore power. The LANGUAGE menu appears. Select the other operating language on the controller, or select a different language file that may be contained on the USB flash drive. Formulas and setup information (operating mode, calibration, etc.) are retained after a language change. Custom formula and pump names are not translated when a language
is changed.
P/N 20-09120-00 Rev. C
© Hydro Systems Company, Inc. 2014
HydroSystemsCo.com
Toll Free: 1.800.543.7184
11