Download User`s Manual
Transcript
AT-140GE 5. Pin Assignment 5.1. 12-pin Multi-connector (DC-IN/Digital IO) Type: HR10A-10R-12PB-01 (Hirose) male. (Seen from rear of camera.) 9 1 2 8 10 11 3 4 7 12 5 6 Fig. 3. 12-pin connector. Pin no. Signal Remarks 1 GND +12V to +24V 2 DC input 3 Opt In 2(-) / GND (*1) Line 6 4 Opt In 2 (+) / Iris video(*1) 5 Opt In 1 (-) Line 5 6 Opt In 1 (+) 7 Opt Out 1 (-)Line 3 8 Opt Out 1 (+) 9 Opt Out 2 (-) Line 4 10 Opt Out 2 (+) +12V to +24V 11 DC input 12 GND *1) Default is Opt In 2. DIP switch SW700 changes to iris video output. 5.2. Digital Output Connector for Gigabit Ethernet Type: RJ-45 HFJ11-1G02E-L21RL or equivalent The AT-140GE cameras also accept industrial RJ-45 connectors with thumbscrews. This assures that the connector does not come undone in tough industrial environments. Please contact the nearest JAI distributor for details on recommended industrial RJ-45 connectors. Fig. 4. Gigabit Ethernet connector The digital output signals follow the Gigabit Ethernet interface using RJ-45 conforming connector. The following is the pin assignment for the Gigabit Ethernet connector. Pin No 1 2 3 4 5 6 7 8 In/Out In/Out In/Out In/Out In/Out In/Out In/Out In/Out In/Out Name MX1+ (DA+) MX1- (DA-) MX2+ (DB+) MX3+ (DC+) MX3- (DC-) MX2- (DB-) MX4+ (DD+) MX4- (DD-) - 11 -