Download The CA200 Calibration System

Transcript
CA200 Calibration System – User manual
The CA200 Calibration System
Introduction
The CA200 Calibration system is used to calibrate a standard transducer, against a reference
transducer, with known characteristics. The system is primarily intended for “field-calibration” of Accelerometers, but also allows for calibration of Velocity- and Displacement sensors, with lower accuracy.
The calibration system consists of three major parts:
•
•
•
The CA200 Calibration Amplifier.
The Vibrograph® Virtual instrument, installed on a PC.
A reference transducer, mounted in a fixture, on top of a shaker.
Picture 1. CA200 Calibration System
Setting up the system
Before using the calibration system, all parts must be properly set-up and connected. The recommended procedure is as follows:
1) Prepare the reference transducer with its fixture, to achieve stable test conditions.
2) Connect the reference transducer and the transducer to calibrate, to Calibration
Amplifier.
3) Install Vibrograph® Virtual instrument software on a PC.
4) Connect Calibration Amplifier to PC, via USB connector.
3