Download manual

Edition 1.0
21/40
TKM60P User’s manual
Picture 32 Selection of the SSI protocol with 25 bit aligned on the centre.
By using the mouse left button select the underlined option that, in the example shown in picture no.32,
corresponds to the SSI protocol with 25 bit aligned on the centre.
At this point the menu closes and in the check box it appears the chosen option.
Picture 33 Selection of SSI protocol for option 25 bit aligned on the centre.
By using the mouse activate the square check box in the first column; a tick sign is displayed to indicate that the
function has been really selected.
Picture 34 Selection SSI protocol function.
At this point, by pressing the
$
#
button you can configure the SSI protocol.
)
/
)
0
This function executes the negation of the output code, carrying out the complement to 1of the single bit.
As default configuration TEKEL sets this function in Normal mode, namely the output code is not inverted.
In order to set the Normal or the Reverse mode open the menu related to this type of function at the right side of
letter L.
In the example it is shown how to enable the complemented code option namely the Reverse mode.
Picture 35 Selection Normal / Reverse option.
By pressing the mouse left button select the underlined option that, in the example shown in picture 35,
corresponds to the enabling of Reverse option.
At this point the menu closes and in the check box it appears the chosen option.
Picture 36 Selection Normal / Reverse option.
By using the mouse activate the square check box in the first column; a tick sign is displayed to indicate that the
function has been really selected.
Picture 37 Enabling of the Normal / Reverse function with Reverse option.
At this point, by pressing the
'
%
button you can configure the SSI protocol.
8
9
The a.m. function enables to set a threshold relevant to the exceeding of a speed ranging from 0 RPM (alarm
always on) to 700 RPM (revolutions per minute). The exceeding of the max speed is indicated through a
dedicated pin on the output connector or through a wire on the cable output. Besides the physical signal the
speed alarm is also displayed on the TKPROG panel (from yellow to red) in the alarm section, picture 38.
The threshold on the alert goes from the green colour to the red one. The indication is yellow when the parameter
has never been read/programmed.
Alarm indication for
max speed exceeding
Picture 38 Alarm window (max speed exceeding and thresholds).