Download Danger Warning Warning CAUTION Warning

Table of Contents
Pg. 5
Pg. 5
Section 1) Receiving and Specifications
1.1) Physical Inspection
1.2) Input Power and Motor Specifications
Pg. 7
Pg. 7
Pg. 8
Pg. 8
Pg. 8
Section 2)
2.1)
2.2)
2.3)
2.4)
2.5)
Physical Installation
Operating Environment
Motor Selection
AC Line Reactors
Wire Size & Specifications
Carrier Frequency
Pg. 9
Pg. 9
Pg. 10
Pg. 10
Section 3)
3.1)
3.2)
3.3)
3.4)
Keypad Operation
Keypad Operating Modes
How to restore the factory program
Operating the RM5 without the keypad
Analog Keypad KP-202 Introduction
Pg. 11
Pg. 12
Pg. 12
Pg. 12
Pg. 12
Pg. 13
Pg. 13
Pg. 13
Pg. 13
Pg. 14
Pg. 14
Pg. 15
Pg. 15
Pg. 15
Pg. 16
Pg. 16
Pg. 16
Pg. 16
Pg. 16
Pg. 17
Pg. 17
Pg. 18
Pg. 19
Pg. 19
Pg. 20
Pg. 21
Pg. 21
Pg. 22
Pg. 24
Pg. 24
Pg. 24
Section 4)
4.1)
4.2)
4.3)
4.4)
4.5)
4.6a)
4.6b)
4.6c)
4.6d)
4.7)
4.9)
4.10)
4.11)
4.12)
4.13)
4.14a)
4.14b)
4.15)
4.16)
4.17)
4.18)
4.19)
4.20)
4.21)
4.22)
4.23)
4.24)
4.25)
4.26)
4.27)
4.28)
Programming Instructions
Quick Start (Primary Settings)
Maximum Frequency Programming
Multiple Speed Level Activation and Frequency Settings
Input Terminal Programming: X1 through X6
Output Terminal Programming: Y1, Y2 and Ta & Tb.
Acceleration & Deceleration Scale
Acceleration & Deceleration Programming
Secondary Acceleration & Deceleration
S-Curve Starting, Leveling and Stopping.
Speed Reference Scale (i.e. Speed Pot Voltage Scale)
Operating Speed Range
Frequency Bypass
Keypad Default Display
User Defined Meter (i.e. MPM) and RPM Calibration
Analog Meter Programming, (outputs FM+ and FM- or GND)
Digital Meter Programming, Auxiliary
Digital Meter Connection Diagram: Plug CN1
Overload Priority Selection (Motor or Inverter)
Overload Signal Parameters
Motor Staring Parameters
Carrier Frequency
Motor Ratings and Overload Parameters
Motor Slip and Stall Parameters
Level Speed Detection Signal
Voltage Frequency Patterns (V/F Pattern)
Power Interruption Ridethough
Power Interruption Controlled Stop Programming
DC Braking (Note: Standard feature on 1 to 5 HP. Optional on 7 ½ HP or above)
Store and Copy Programs
Locking Programs & 400 Hz Motors
Restoring the Factory settings
Page 3