Download metaglas

Transcript
Hydraulic Accumulator Measuring Unit
3.5
Material selection
3.5.1
Introduction
Choosing proper material for the housing is one of the important challenges for our
construction, the parts are static therefore we do not need to consider the factor of wear
resistance due to motion. The most important factor is the surroundings with an external
pressure up to 275 bars, and some places, as a second barrier, an internal pressure of 345
bar.
As we know FMC Technologies has a wide experience from subsea installations, and has a
great knowledge of which materials that can be used in these environments. We will in
chapter 3.5.3 comment different materials that can be used for our assembly.
3.5.2
Challenges
The main concern is the seawater surrounding the housing; the seawater is highly corrosive
due to dissolved salts, ions. Therefore the material of the housing needs to have a high
corrosion resistance. To protect the subsea installations from corrosion it is common to use
a sacrificial anode on the installation, the anodes are generally cast aluminum alloys or in
some cases zinc and magnesium alloys.
Another challenge is the hydrostatic pressure the housing has to withstand; this comes from
the weight of the seawater, in other words the sea column. As mentioned earlier the
external pressure will be 275 bar.
We also have to consider the viewing we need to have into the accumulator, this material
needs to withstand an internal pressure of 345 bar and be transparent.
Page 31