Download CruzPro

Calibrating a Data Source
Calibrating the displayed data is possible for many of the Data Sources. Press
and hold the & and " keys for ten seconds to enter the Calibration Editor (until
you hear a long beep). The data source value, display identifier (1, 2, 3, L or
r) and the word “CAL” will be displayed as shown in Figure 22. Quick press
the & key to select the desired display identifier (1, 2, 3, L or r). Press and
hold the % and $ keys to change the calibration value. Press the & key for 1
second (until the long beep) to accept the new value, save it to memory and
leave the Calibration Editor mode.
Figure 24 - Calibration Editor
Editing the calibration for the Data
Source shown on digital display #2
When calibrating the Time-Of-Day clock a Clock Calibration value between 0
and 100 (nominal value is 50 ) will be shown on Display #1 and the time of day
shown on Display #3. Increase the Clock Calibration value to speed up the
clock, decrease the Clock Calibration value to slow down the clock. Increasing the Clock Calibration value by one will increase the clock speed by 1
second per day. Decreasing the Clock Calibration value by one will decrease
the clock speed by 1 second per day.
Page 23