1
Download SIP User`s Manual
Transcript
SIP User's Manual 3. Web-Based Management Parameter nnection] Description [1] Yes (default) Notes: Broken Connection Timeout [BrokenConnectionEven tTimeout] The timeout is set by the parameter BrokenConnectionEventTimeout. This feature is applicable only if the RTP session is used without Silence Compression. If Silence Compression is enabled, the device doesn't detect a broken RTP connection. During a call, if the source IP address (from where the RTP packets are sent) is changed without notifying the device, the device filters these RTP packets. To overcome this, set DisconnectOnBrokenConnection to 0; the device doesn't detect RTP packets arriving from the original source IP address and switches (after 300 msec) to the RTP packets arriving from the new source IP address. The time period (in 100 msec units) that an RTP packet is not received after which a call is disconnected. The valid range is 1 to 1,000. The default value is 100 (i.e., 10 seconds). Notes: Disconnect Call on Silence Detection [EnableSilenceDisconne ct] Applicable only if DisconnectOnBrokenConnection = 1. Currently, this feature works only if Silence Suppression is disabled. Determines whether calls are disconnected after detection of silence. [1] Yes = The device disconnects calls in which silence occurs (in both call directions) for more than a user-defined time. [0] No = Call is not disconnected when silence is detected (default). The silence duration can be set by the FarEndDisconnectSilencePeriod parameter (default 120). Note: To activate this feature, set EnableSilenceCompression and FarEndDisconnectSilenceMethod to 1. Silence Detection Period [sec] [FarEndDisconnectSilen cePeriod] Duration of silence period (in seconds) prior to call disconnection. The range is 10 to 28,800 (i.e., 8 hours). The default is 120 seconds. Silence Detection Method [FarEndDisconnectSilen ceMethod] Silence detection method. Enable Fax Re-Routing [EnableFaxReRouting] Note: This parameter is applicable only to devices that use DSP templates 2 and 3. [0] None = Silence detection option is disabled. [1] Packets Count = According to packet count. [2] Voice/Energy Detectors = N/A. [3] All = N/A. Enables or disables re-routing of Tel-to-IP calls that are identified as fax calls. [0] Disable = Disabled (default). [1] Enable = Enabled. If a CNG tone is detected on the Tel side of a Tel-to-IP call, a 'FAX' prefix is appended to the destination number before routing and manipulations. An entry of ‘FAX’ as destination number in the 'Tel-to-IP Routing' table is then used to route the call, and the destination number Version 5.6 155 November 2008
