Download AT Command reference guide for ZTEWelink Module

AT Command reference guide for ZTEWelink module
Description
This parameter specifies the amount of time, in seconds, that the DCE shall pause, during signaling of call
addressing information to the network (dialing), when a "," (comma) dial modifier is encountered in a dial string.
Defined values
<val>:
0
DCE does not pause when "," encountered in dial string.
1 to 255
Number of seconds to pause.
NOTE:
the define value is 2, and the value can be available from the inquery command AT&V.
3.3.2.9
Automatic Time Zone Update +CTZU
Syntax
Table 3.3.3-10: +CTZU parameter command syntax
Command
Possible response(s)
+CTZU=<onoff>
+CME ERROR: <err>
+CTZU?
+CTZU: <onoff>
+CME ERROR: <err>
+CTZU=?
+CTZU: (list of supported <onoff>s)
+CME ERROR: <err>
Description
Set command enables and disables automatic time zone update via NITZ. If setting fails in an MT error, +CME
ERROR: <err> is returned.
Read command returns the current settings in the MT.
Test command returns supported on- and off-values.
Defined values
<onoff>: integer type value indicating:
0 – Disable automatic time zone update via NITZ (default).
1 – Enable automatic time zone update via NITZ.
3.3.2.10 Time Zone Reporting +CTZR
Syntax
Table 3.3.3-11: +CTZR parameter command syntax
Command
Possible response(s)
+CTZR=<onoff>
+CME ERROR: <err>
23
All Rights reserved, No Spreading abroad without Permission of ZTEWelink