Download AT Command reference guide for ZTEWelink Module

AT Command reference guide for ZTEWelink module
Extensible AT command, this command is used to Set the DTE-DCE flow control without USIM. This is similar to
+IFC. It acceps one numeric parameters which is used to control the operation of local flow control between the
DTE and DCE during the data state when v.42 error control is being used, or when fallback to non-error control
mode is specified to include buffering and flow control.
Defined values
<State>:
0: Disable flow control (IFC=0,0)
3: Enable RTS/CTS（default for data modem）(IFC=2,2)
4: Enable XON/XOFF (IFC=1,1)
5: Enable transport XON/XOFF (IFC=3,1)
e.g.
AT+ZFLOW=0 //Disable flow control
OK
AT+ZFLOW=?
+ZFLOW: (0-5)
OK
AT+ZFLOW?
+ZFLOW: 0
OK
3.3.20.8 Set Encoding Format: +ZIPCODE
Syntax
Table 3.3.20-8: + ZIPCODE parameter command syntax
Command
Possible response(s)
+ZIPCODE=<CODE_TYPE>
OK
or
ERROR
+ZIPCODE?
+ZIPCODE: <CODE_TYPE>
Description
This command is an extended command, and it is used to query and set the encoding format of transmit data. Now
module MF206A supports ASCII and binary encoding format, and the default encoding format is binary.
Defined values
<CODE_TYPE>: the encoding format of transmit data
0：ASCII
1：BINARY
165
All Rights reserved, No Spreading abroad without Permission of ZTEWelink