Download Response NETWORK CONTROLLER User manual

30
Response NETWORK CONTROLLER
Selecting a setup table
The Response NETWORK CONTROLLER can create and store up to
eight setup tables. The setup table that appears on the Setup display
does not necessarily control your system; you must select the
desired setup table, then reset the system to enable it. You can
enable a setup from the Setup display. Or, if you are using the
Response NETWORK CONTROLLER without a terminal, you can
use hardware jumpers inside the controller.
Enabling a setup table from Setup display
In most cases you will probably use the Response NETWORK
CONTROLLER in the software mode, using the Wyse WY-50
terminal keyboard to configure your system. Follow these steps to
enable a setup in software mode:
1. Press [F3] (Setup); then press [F6] (Jumpers).
2. Enter the desired setup table number (0 through 7); then press
[Return].
3. Press [E] to enable the desired setup option.
4. Press [F16] (Reset) to reset the controller and enable the
selected setup configuration.
Enabling a setup table without a terminal
When operating the Response NETWORK CONTROLLER without a
terminal, you set hardware jumpers to select setup tables. Follow
the steps in Appendix C to select and enable a setup in hardware
mode.