Download Reference Manual PM94P01C__Position Servo PC-based
Transcript
Programming 2.15.9.11 Homing Method 11: Homing on the Home Switch & Index Pulse Using this method the initial direction of movement is negative (if the homing switch is inactive). The home position is the first index pulse to the positive of the position where the homing switch becomes active. Axis will accelerate to fast homing velocity in the negative direction and continue until Homing Switch (selectable via Var_Home_Switch_Input Variable) is activated (rising edge) shown at position A. Axis then decelerates to zero velocity. If the homing switch is already active when the homing routine commences then this initial move is not executed. Axis will then accelerate to fast homing velocity in positive direction. Motion will continue until first the falling edge of the Homing switch is detected (position B) and then the rising edge of the first index pulse (position 11) is detected. NOTE: if the axis is on the wrong side of the homing switch when homing is started then the axis will move negative until it contacts the negative limit switch (A1). Upon activating the negative limit switch the axis will change direction (positive) following the procedure as detailed above, but moving positive instead of negative and without stopping on detection of the homing switch rising edge. A B B 11 11 Index Pulse (via Input C3) Homing Switch (Var_Home_Switch_Input) Figure 35: Homing Method 11 PM94P01C 69