Download CTELL Case Interface Manual

Interface Manual (3/29/03), p. 21
incorrectly created, may not play back your segment correctly, or may "freeze" your computer
requiring a re-start.
NOTE 2: To create a new bookmark after viewing an existing bookmark, click "New" and
follow the instructions listed under "Creating a bookmark," below.
Creating a bookmark
1. Once the video has completely downloaded into the video window, click on the
bookmark tab (see Figure 13, above).
2. Play the video in the video window until you reach the place you want to start your
segment. (If you have a rough idea of where you want to begin your segment, you can
drag the slide control on the playback bar under the video window to move to that
approximate location.) That is, you can click-hold and drag the circle below the video
window to move through the video once it has downloaded completely.)
3. With the video paused at the beginning of the segment that you wish to define (you can
start and pause the video by clicking on the small, "play" triangle at the left side of the
playback bar under the video window), click the "Set Start" button. This will set the
beginning of the bookmark at the beginning of the clip you want (you will see a time
code entered into the box beside the "Set Start" button).
4. To find the end of the segment that you wish to define, either let the video play to that
point or drag the slide button on the playback bar under the video window to the end of
the segment that you want to define. Click the "Set End" button (you will see a time
code entered into the box beside the button).
5. Provide a name for the bookmark by typing a name in the "Title" space. Write any
notes or comments that you would like to make in the "Notes" field.
6. Check the bookmark by clicking on the "View" button under the "Notes" field. Clicking
"View" will play your segment so that you can confirm that you have captured what you
wish, but the "View" button does not save your segment for later use.
7. Save your bookmark by clicking the green "Save" button.
Some hints and cautions about bookmarks
• The bookmarks that you define are not saved automatically, so it is important to click
save after you create each one.
• To move in small increments to define your start and end points for a video segment,
use the two arrows to the right of the playback bar under the video window.
• To reset the start and end boxes after you have saved the bookmark, click the reset
button to the left of the view button.
Once you have created and saved a bookmark, it will appear in the bookmarks list below the
"Reset" button. This list will contain all of the bookmarks made and saved under your login
name and will be available for your use whenever you login using your password, until you
throw away a bookmark by moving it to the trash can at the lower right corner of the interface.