Download User`s Manual

Transcript
2. Underlying Dome Geometry
A number of different underlying dome geometries are available from the Dome Geometry tab of the plug-in.
While the shapes may be different, all may have a cylinder attached and all have a helical winding pattern
described by the following equation:
 R0 
 R  R0 
 ( R)  sin 1     

 R
 Rtl  R 0 
n
Equation 2.1: Wing Angle Definition
Here, R is the radial distance from the center line to a point in the layer, Ro is the radial distance from the
centerline to the turnaround point, and Rtl is the radius at the dome-cylinder tangent line. A frictionless
winding pattern is obtained by choosing  = 0. If friction is accounted for,
distribution will vary as described in later sections.
 ≠ 0, then the wind angle
2.1 Geodesic Dome
The geodesic-shaped dome is a specially shaped dome which results in a constant strain state along much
of the fiber as it wraps around the dome. The shape of the dome is directly related to the vessel radius and
the wind angle of the layer at the tangent line.
The wind angle defining the geodesic dome shape is specified in one of two ways. Firstly, a base wind angle
may be specified directly from the Dome Geometry tab as shown in the figure below. Secondly, if the base wind
angle has not been specified, then the wind angle of the first helical layer defined under the Winding Layout tab
is used to determine the geodesic shape.
5