Download User`s Manual

Transcript
Figure 2.3: User-Defined Dome Input
2.4 From-Part Instance Dome
Wound composite layers can be made to wrap over an existing part instance that has been meshed within
Abaqus/CAE. The part instance must be meshed, but may have been created from an imported orphan
mesh, native geometry, or imported geometry. The points of the underlying wound composite dome
geometry are extracted from the nodal coordinates along the outer surface of the part instance.
In order to define the outer surface which may be overwrapped, the user is required to generate a node set.
In the case of a three dimensional model, this node set should be in the x-y plane with the axis of the tank in
the global y-direction. The plug-in then generates the dome geometry from all of the nodes between the first
and last nodes. The option of connecting the points using straight lines segments or splines is available.
Figure 2.4: Helical Layers on Part Instance
8