Download User Manual
Transcript
2-12 INSTALLATION ORBAN MODEL 9300 Four Soft buttons provide access to all 9300 functions and controls. The functions of the soft buttons change with each screen, following the labels at the bottom of each screen. Next and Prev ( and ) buttons scroll the screen horizontally to accommodate menus that cannot fit in the available space. They also allow you to move from one character to the next when you enter data into your 9300. These flash when such a menu is in use. Otherwise, they are inactive. Control Knob is used to change the setting that is selected by the soft buttons. To change a value, you ordinarily have to hold down a soft button while you are turning the control knob. Recall button allows you recall a Factory or User Preset. Selecting the Recall button does not immediately recall a preset. See step 16 on page 2-18 for instructions on recalling a preset. Modify button brings you to list of controls that you can use to edit a Factory or User Preset. If you edit a Factory Preset, you must save it as a new User Preset to retain your edit. Setup button accesses the technical parameters necessary to match the 9300 to your transmission system. Escape button provides an escape from the currently active screen, returning the user to the next higher-level screen. Repeatedly pressing Escape will always return you to the Idle screen, which is at the top level of the screen hierarchy. Input meters show the peak input level applied to the 9300’s analog or digital inputs with reference to 0 = digital full-scale. If the input meter’s red segment lights up, you are overdriving the 9300’s analog to digital converter. This clips at +27 dBu. AGC meter shows the gain reduction of the slow two-band AGC processing that precedes the separate analog and digital processing chains. Full-scale is 25 dB gain reduction. You can switch the meter so that it either reads the gain reduction of the Master (above-200 Hz) band, the Bass (below-200 Hz) band, or the difference between the gain reduction in the Master and Bass bands. The latter reading is useful for assessing the dynamic bass equalization that the AGC produces and it helps you set the AGC BASS COUPLING control. Gate LED indicates gate activity, lighting when the input audio falls below the threshold set by the AGC gate threshold control (via the Full Control screen’s AGC GATE control). When this happens, the AGC’s recovery time is slowed to prevent noise rush-up during low-level passages.