Download MaxFilter 2.0 Manual

Transcript
B
Elekta Neuromag MEG sensors
Type
Nk
Description
rk
wk
2
Neuromag-122
planar gradiometer
8
( ± 5.44, ± 7.68, 0 )mm
( ± 11.1, ± 7.68, 0 )mm
± 1 ⁄ ( 4 ⋅ 16.2mm )
3012
Type T1
planar gradiometer
Type T2
planar gradiometer
Type T3
planar gradiometer
8
( ± 5.89, ± 6.71, 0.3 )mm
( ± 10.8, ± 6.71, 0.3 )mm
± 1 ⁄ ( 4 ⋅ 16.69mm )
Type T1
magnetometer
Type T2
magnetometer
9
( 0.0, 0.0, 0.3 )mm
Type T3
magnetometer
9
3013
3014
3022
3023
3024
( ± 9.99, ± 9.99, 0.3 )mm
( 0.00, ± 9.99, 0.3 )mm
( ± 9.99, 0.0, 0.3 )mm
16 ⁄ 81
25 ⁄ 324
10 ⁄ 81
10 ⁄ 81
( 0.0, 0.0, 0.3 )mm
( ± 8.13, ± 8.13, 0.3 )mm
( 0.0, ± 8.13, 0.3 )mm
( ± 8.13, 0.0, 0.3 )mm
16 ⁄ 81
25 ⁄ 324
10 ⁄ 81
10 ⁄ 81
Table B.1 MEG coil descriptions.
B.2 Scaling between magnetometers and gradiometers
The Elekta Neuromag® data contains both magnetometer and planar gradiometer channels which have different SI units (T and T/m, respectively). Therefore, some scaling between the channel data and basis
functions has to be applied before combining them for Maxwell filtering.
MaxFilter utilizes the inherent RMS noise levels of the sensors:
n m = 3 fT/sqrt(Hz) for magnetometers,
n g = 3 fT/cm/sqrt(Hz) for gradiometers.
The basic modelling equation ( b = Sx , see Appenix A.2), is presented in
the form
diag ( w )b = diag ( w )Sx
where the weight for the kth channel is w k = n g ⁄ n k . Thus, the gradiometer channel weight becomes 1, while the magnetometer channel weight is
100.
Optionally, the weight w k for magnetometers can be set with the command-line option -magscale mult; the gradiometer weight is still one.
50
2006-10-31
NM21993A