Download OPERATION MANUAL

3.
Manual Operation
Power switch
Once connected to the AC mains, the power switch controls the power supplied to the unit. Be
sure to set the power switch to ON before operation.
In the event of a power disconnect, when power is restored, the unit will return to its operating
state.
Note: Once the power switch is set to ON, the cooling fan should immediately operate. If the fan
fails to turn on with the power switch, but the unit is still able to output light, set the power switch
to OFF and contact the manufacturer.
Pushbuttons
There are two pushbuttons on the side of the unit labeled “Wheel Speed” and “Mode” shown in
Figure 1.
WHEEL SPEED
If a twinkle wheel is installed in the fixture, the “Wheel Speed” pushbutton is used to control the
twinkle wheel. Pressing this pushbutton cycles through different preset twinkle speed modes with
rotation in one direction (Note: Both forward and reverse rotation can be controlled with DMX).
Each mode corresponds to different twinkle speeds as described in the Table 1 below.
Table 1: Preset twinkle speed modes that can be selected using the “Wheel Speed” pushbutton
Mode
0
1
2
3
4
5
FiberLamp
Copyright 2013
Wheel Speed
Off
Slow
Slow-med
Medium
Med-fast
Fast
Manual Operation
Page 6 of 20
5870049 A2