Download Quartet imaging Housing Frame

Transcript
3.11 imaging Extender Module
The optional imaging extender module allows easy access to any imaging series modules
requiring testing, repairs, or calibration. In order to install the extender module, remove the
imaging module under test from the housing frame. Replace it with the extender module.
Insert the module under test in the extender module making sure it is firmly installed. Refer
to the Figure 3.13.
To remove the module under test, simply push on the ejectors situated at the front of the
extender module and pull out the module under test. To remove the extender module,
carefully pull on it in order to detach it from the housing frame's rear motherboard.
For complete instructions on module installation and module removal, refer to sections 3.7
and 3.8 respectively.
Figure 3.13 imaging extender module setup
imaging Extender Module
To
imaging
Quartet
Tray
Install
module under
test here
Ejector used to remove module under test
(To remove module, push ejector in direction of arrow.)
23