Download 8.5 Settings - Merging Technologies

9 Recording and Editing
Be sure that both reference video input on the synchronization panel of the VCube and the video card reference input are
referenced to the same genlock, black and burst, or video signal. This is the only way to ensure a precise timing for the video
signal.
Enable Capture button activates the video card specific function. Ctrl + R
Uncheck Enable Capture to make the capture visible in the Timeline.
Auto Edit mode enables VCube to automatically control a VCR via a Sony 9 Pin protocol, and to record a range of the video
tape from In point to Out point set in the Internal machine panel T.
During this process, VCube needs to be in chase mode. To bypass possible drop outs in the Reference TimeCode source,
Soft Chasing can be used, in this case the video card must be referenced to an external reference signal
Output Path is a browser where you have to select the destination for the captured media. The destination folder for
ingested Media Files should be on a local hard disk drive. The SD VCube ‘D’ hard disk drive has a 120 GB capacity for
storing your Media Files.
File Name is a dialog where you can enter a generic name for future media captures.
Counter is a dialog where the start point of the incrementation process is set. All captured Media Files will have a generic
name followed by an automatically incremented number.
Preroll is the time value to advance the VCR start up in Auto Edit mode.
Postroll is the time value to delay the VCR stop in Auto Edit mode.
Offset is a dialog where you can adjust offset between the incoming and the recorded TimeCode. Only the time stamp of the
recorded Media File is affected by this setting.
98
9