Download VMA-200E ATM Adapter User`s Manual

Troubleshooting
How to check Enter the elconfig show -configured command and note the last error message in the
output.
Possible Solutions Last error messages and corrective actions are mentioned with each case below.
•
LES address is zero ( only in autoconfig mode ) or VCI not assigned for LES (only in manual configuration).
1.
"LECS failed to find ELAN"
Ensure that the ELAN name is correct and is registered with the LECS (in case
of auto-configuration only).
2.
"LECS failed to respond"
If in auto-configuration mode, make sure that the LECS is started and is
running.
3.
"failed to connect to LES" or
"Could not connect to the BUS"
Make sure that the services (LES,BUS) are up, and that the services machine is
connected to the switch. Make sure that the ATM address of the services
machine is correct in the LECS database.
4.
If services are UP, check the syslog file (if enabled) for any ERROR conditions
and make corrections as appropriate. If services are UP but syslog is not
enabled, call FORE Technical Support.
5.
Enter the command atmstat fa0 1 and observe the response.
a.
If atmstat does not respond, call FORE Technical Support.
ForeRunner™ VMA-200E ATM VME Bus Adapter User’s Manual
10 - 17
Troubleshooting
What is the "Last Error" appearing in the output of the elconfig
show -configured command?