1
Download 4Motion System Manual, Ver.3.5
Transcript
Chapter 3 - Operation and Administration of the Macro BTS 3.4.2.3.5 NOTE! NPU Configuration Configuring/Modifying the VLAN ID for an IP Interface You can modify the VLAN ID for only the bearer, local-management and external-management interfaces. If you change the VLAN ID of the bearer interface, you must change the bearervlanid of all AUs (see “Configuring AU Connectivity” on page 440) to the same value. Run the following command to modify the VLAN ID for this interface: npu(config-if)# if_vlan <vlanid(9 | 11-100 | 110-4094)> INFORMATION Refer Table 3-10 for the default VLAN IDs assigned to the bearer, local-management and external-management interfaces. NOTE! An error may occur if: The VLAN ID you have specified is not within the specified range, or is in use by another interface. Refer the syntax description for the VLAN ID range. The VLAN ID is already used as a translated VLAN or a VLAN translation entry already exists for this VLAN. You are trying to run this command for the internal-management interface. You can modify the VLAN ID for only the external-management, local-management or bearer interfaces. Command Syntax npu(config-if)# if_vlan <vlanid(9 | 11-100 | 110-4094)> Privilege Level 10 4Motion System Manual 140
