Download Recording Component: RC-L/RC-E

RC-L / RC-E User Manual Management Client elements
REMOTE RETRIEVAL TAB
On the Remote Retrieval tab, you can handle remote recording retrieval settings for the remote site in an
Interconnect setup:
Specify the following properties:
Name
Description
Retrieve recordings at max
Determines the maximum bandwidth in Kbits/s to be used for retrieving
recordings from a remote site. Select the check box to enable limiting
retrievals.
Retrieve recordings between
Determines that retrieval of recordings from a remote site are limited to a
specific time interval.
Unfinished jobs at the end time continue until completion, so if the end time
is critical, you need to set it earlier to allow for unfinished jobs to complete.
If the system receives an automatic retrieval or request for retrieval from
the Ocularis Client outside the time interval, it is accepted, but not started
until the selected time interval is reached.
You can view pending remote recording retrieval jobs initiated by the users
from System Dashboard -> Current Tasks.
Retrieve on devices in parallel
Determines the maximum number of devices from which recordings are
retrieved simultaneously. Change the default value if you need more or less
capacity depending on your system's capabilities.
When you change the settings, it may take several minutes until the changes are reflected in the system.
None of the above applies to direct playback of remote recordings.
All cameras set to be played back directly is available for direct playback and use bandwidth as needed.
Remove a recording server
Important: If you remove a recording server, all configuration specified in the Management Client is removed for the
recording server, including all of the recording server's associated hardware (cameras, input devices, and so on).
1.
Right-click the recording server you want to remove in the Overview pane.
2.
Select Remove Recording Server.
3.
If you are sure, click Yes.
4.
The recording server and all of its associated hardware are removed.
Delete all hardware on a recording server
Important: When you delete hardware, all recorded data related to the hardware is deleted permanently.
1.
Right-click the recording server on which you want to delete all hardware.
2.
Select Delete All Hardware.
3.
Confirm the deletion.
On-Net Surveillance Systems, Inc.
51