Download User Manual

Transcript
KY-3120DM Industrial Ethernet Switch User Guide
and the default value is 200 milliseconds.
leave: sets the GARP Leave timer. The argument ranges from 10 to 2147483640,
and the default value is 600 milliseconds.
leaveall: sets the GARP Leaveall timer. The argument ranges from 10 to
2147483640, the default value is 10000 milliseconds.
timer-value: timeout time (in milliseconds) of the GARP timer (Hold, Join, Leave
or Leaveall ) to be set.
Description
Use garp timeout command to set a GARP timer.
Use no garp timeout command to restore to the default setting of a GARP timer.
Examples
# garp timeout hold 50
Configuration was successful.
Gvrp
Syntax
gvrp
no gvrp
View
System view.
Ethernet port view.
Parameters
None.
Description
Use gvrp command to enable GVRP globally (in System view) or for a port (in
Ethernet port view).
Use no gvrp command to disable GVRP globally (in System view) or for a port (in
Ethernet port view).
By default, GVRP is disabled both globally and on a port.
Examples
# gvrp
Global gvrp has been enabled successfully.
Gvrp registration
Syntax
gvrp registration {fixed | forbidden | normal}
no gvrp registration
View
Ethernet port view
Parameters
fixed: specifies the fixed GVRP registration mode. A port operating in this mode
cannot register or deregister VLAN information dynamically. It only propagates
static VLAN information. Besides, the port permits only static VLANs, that is, it
propagates only static VLAN information to the other GARP members.
103