Download CLC SequenceViewer

CHAPTER 5. PRINTING
73
Figure 5.4: A print of the sequence selecting Print whole view. The whole sequence is shown, even
though the view is zoomed in on a part of the sequence.
5.2
Page setup
No matter whether you have chosen to print the visible area or the whole view, you can adjust
page setup of the print. An example of this can be seen in figure 5.5
Figure 5.5: Page Setup.
In this dialog you can adjust both the setup of the pages and specify a header and a footer by
clicking the tab at the top of the dialog.
You can modify the layout of the page using the following options:
• Orientation.
Portrait. Will print with the paper oriented vertically.
Landscape. Will print with the paper oriented horizontally.
• Paper size. Adjust the size to match the paper in your printer.
• Fit to pages. Can be used to control how the graphics should be split across pages (see
figure 5.6 for an example).
Horizontal pages. If you set the value to e.g. 2, the printed content will be broken
up horizontally and split across 2 pages. This is useful for sequences that are not
wrapped
Vertical pages. If you set the value to e.g. 2, the printed content will be broken up
vertically and split across 2 pages.
Note! It is a good idea to consider adjusting view settings (e.g. Wrap for sequences), in the
Side Panel before printing. As explained in the beginning of this chapter, the printed material will
look like the view on the screen, and therefore these settings should also be considered when
adjusting Page Setup.