1
Download KT300
Transcript
User’s Manual of KT300 Intelligent Diagnostic Instrument Safety Precautions Testing in good-ventilation condition, vehicle exhaust pipe should be connect to outside without enough ventilation. No smoking or fire while testing. Battery liquid of car contains vitriol that corrupts skin, so while operation you must be careful not to touch it directly especially paying more attention to your eyes. The engine works in high temperature, so you should keep away from the water tank and exhaust pipe and some other hot parts. Before starting the engine, you should pull the MT brake, particularly prevent the front wheel moving, and place the gear lever in P/N to avoid the car rushing out to hurt someone while started. If the battery is used as power supply, the red alligator clip should be connected with the battery positive and the black one with the negative. When the instrument is used in the engine chamber, all the power supply leads, the meters and the tools should be far away from the strap or other moving machines. Don’t wear watch and ring as well as large and wide clothes in the engine chamber In the process of car testing, you should wear the permissive safety glasses. Notice This unit is a hi-tech and hi-precision electronic instrument for Automotive Diagnosis, so never shake or hit while operating. Tested for the first time, the instrument may respond slowly; but wait patiently and don’t operate it frequently. The screen may blink for a moment while the engine is igniting. This is normal. If it does not run or the screen is not stable after blinking, please turn off the power supply and then try again. Make sure it is connected properly with the diagnostic connector to prevent the signal from being interrupted. Without normal connection, please pull out the connector and insert it again. Don’t shake the connector acutely while using. Try not to take down the KT600 protection cover while using it. You should try to place it on the level with the screen upwards. Try to fasten the extension leads and the connectors with snails to avoid disconnect and destroy port. When pulling out the connector, please hold firmly the front end, and don’t pull the back end of the extension leads. Try your best to carry and put it softly in safety place. Avoid colliding. If no use, please disconnect power supply. After using you should insert the touching pen in the socket in the upper-right corner of the main unit and put back fittings in the box in case of losing. Your local network influences the speed of on line upgrading. If you download at a low speed please wait patiently. The operation of the instrument needs relevant knowledge about vehicle maintenance and ECU. Bosch Automotive Diagnostic Equipment (Shenzhen) Co., LTD WWW.KINGTEC.NET
