Download COMMS GENIUS USER MANUAL DRAFT

SENS CommsGenius Technical Manual
2.2. Setup Dual IQ Charger Synchronizing and Load Share
Note: If using a remote temperature sensor with dual charger synchronization/load share,
ensure temperature compensation is active on both chargers before connecting the REMOTE
Charger Data cable. See the EnerGenius IQ charger manual for information on activating
temperature compensation.
2.2.1.
REMOTE Charger Data Port Connection Requirements
Use the provided REMOTE Charger Data cable to connect the REMOTE charger for
dual charger systems. The cable enters both chargers at the opening at the top left side of
the chassis. Keep signal cables away from the AC and DC power wiring!
Figure 7: Load Share Connection Diagram
2.2.1.1.
Connection at the CommsGenius
• Attach the sensor wires to the three-position connector provided with the
CommsGenius communications board. Be sure the wire order in the connector
(shield at top, then red, then black) is correct per the orientation shown in
Figure 8 (wires on left, with screws facing the installer).
Figure 8: REMOTE Charger Data Cable Connection at CommsGenius
7