Download SyCon - System Configurator for Ethernet and serial

Settings
5.2.3.2
37/132
Ethernet
Figure 21: Settings > Ethernet Parameter > Ethernet
Description:
The description of the device is shown in SyCon as the name of the device.
The description is changeable in this field.
Auto detect:
An automatic detection of the Ethernet interface results if this option is
selected.
Interface:
Here the manually setting of the Ethernet interface can be done. The user
has the possibility to select Twisted Pair or AUI but at the moment just
Twisted Pair is supported. The description of this you find in section
Twisted Pair and AUI at page 126.
Duplex mode:
Duplex mode of the Ethernet interface. You can select between Full Duplex
and Half Duplex but only Half Duplex is supported at the moment. The
description of this you find in section Full Duplex and Half Duplex at page
126.
Speed:
Transmission speed of the data.
Set MAC address:
If this option is selected you activate the manual MAC address
configuration. If this option is not selected the card has the default address
which was set by the manufacturer.
MAC address (hex):
Here you can enter the manual settings of the MAC address of the device.
The address format is 6 byte in the Hex Code.
SyCon | System Configurator for Ethernet and serial Protocols
DOC040601OI04EN | Revision 4 | English | 2012-06 | Released | Public
© Hilscher, 2004-2012