Download Manual - Kantronics

MT1200 Jumpers
Jumper Locations
➔
To locate jumpers listed below, use the schematic (pdf schematic file located on the cd
shipped with the unit and the parts layout in Appendix D.
Jumper #
J1
J2
J3
J4
J9
Printed
Schematic
Location
A-4
D-2
D-2
C-1
A-4
Name
LED test, Hard Reset
receive audio equalization
receive audio input impedance
normal/HT
Flash test/Load
Note: If your MT1200 was purchased without the internal GPS, and you wish to use
data from an external GPS (or other) device, you will need to solder in a jumper
connecting the pads at position R27. Then, your device output should be connected to
the XCD input (pin 2 on the radio port) of the MT1200.
135