Download I-PAK VH User Manual

Chapter
3
Setup Mode Reference
Although the OCV Tool ignores the symbols during OCV inspection,
the AutoFind still uses those symbol positions as templates if they
were assigned as templates when the tool was trained. If you wish to
ignore completely symbol positions at runtime, you must ensure that
those symbol positions are not used by the AutoFind.
Results Reporting
This section allows you to configure I-PAK VH to output selected
inspection results through the RS-232 Communications Port and/or to a
file on the PC. This may be useful when you need a matrix match or read
string or a Font Tool’s string to be communicated to an external device at
runtime, in the case of RS-232 Runtime Result, or to log inspections at
runtime, in the case of Save Runtime Results to a File.
In either case, the setup is similar. I-PAK VH presents a list of inspection
results to upload as part of the Inspection Step. These are noted as Select
Results to Upload on the Inspection Step’s property page. I-PAK VH
selects certain results our users are most interested in automatically.
These can easily be seen on the Run Mode Display Results window.
To use these features, verify that any inspection results you might need
are selected on the Inspection Step’s property page in the Select Results
to Upload field and enable an RS-232 port on the System Settings >
Communication dialog box.
•
Enable RS-232 Runtime Results — By default, this selection is
disabled until you enable an RS-232 port. Once a port is established,
you can select this option. Exit the Advanced SubMenu and go to the
Statistics and Data SubMenu. You will notice an additional button
available on the Statistics and Data SubMenu called RS-232 Results,
as shown in Figure 3–51.
FIGURE 3–51. Updated Statistics SubMenu for RS-232 Results
Click RS-232 Results and go into the dialog box (see Figure 3–52).
3-74
I-PAK VH User Manual