Download USER`S MANUAL
Transcript
Chapter 13: The Symbol Menu INSERT SYMBOL The INSERT SYMBOL command is used to put copies of a symbol in the drawing. Before you can use this command you must have a library of symbols defined (use CREATE SYMBOL) and you must have loaded the library containing the symbols (use SELECT LIBRARY and LOAD SYMBOL). Procedure: 1. Activate the INSERT SYMBOL command by selecting it from the Symbol menu. If the command is greyed out, it means you have not loaded any symbols. 2. A dialog box will come up with a list of available symbols. Select the one you want to use, and then click the "OK" button. 3. As you move the mouse around, you will see the symbol "attached" to the mouse cursor. When you have the symbol in the position you want, click the left mouse button to insert the symbol. You can also specify where the symbol should be inserted by typing a position in coordinate format. To insert the same symbol again, just click where you want it to be. To insert a different symbol, select the command again from the Symbol menu. Symbols can be broken into component pieces using EXPLODE. SELECT LIBRARY The SELECT LIBRARY command allows you to select a library file. Once you have selected a library, you can use LOAD SYMBOL, LOAD OBJECT, or LOAD GROUP to load symbols, objects or groups from it. PatternMaker designates one file at a time as the current library. If you open another library, the first one is closed. Procedure: 1. Choose "Select Library" from the Symbol menu. (If a library is already open, a message box appears, asking you to confirm closing it before opening the new one.) 2. The Open File dialog box appears. Select a file to use as the library. Any PatternMaker drawing file (.PAT format) can be used as a library. 3. Select a file and click the "Open" button. The selected library will be loaded. Any PatternMaker drawing file (.PAT format) can be selected to use as a library, but in order to be used it must contain a defined symbol, a named object or a named group. It is wise to give your purpose-built library files descriptive names, such as “LIBRARY1.PAT”. LOAD SYMBOL The LOAD SYMBOL command loads a symbol from a library. Once you have loaded a symbol, it will be available to use with the INSERT SYMBOL command. 83