Download USER`S MANUAL

Figure 5-9: Typical Point Configuration pop-up
The Range field allows you to enter the range of the device. The
Operating Point field allows you to specify the device's expected
mid-range operating value, which is usually the most accurate point
within that range. Point Help then calculates the correct offset and
gain for that point. Use the Calibrate button on the Point Help Page
to easily modify the offset parameter to match the device readings.
To configure a point
1. Display the Parameter page of the FB to be configured.
2. Pick the Point Help button, or press the Esc key and issue
the pointhelp manual command. The Point Help page will
appear.
3. Select the point to be changed.
4. Pick the Configure button. A pop-up will appear,
displaying only the signal types which are compatible for the
module which contains the point.
5. Select the type of signal which is wired to the point and press
OK to continue or Cancel to abort.
6. On the pop-up which appears next (see Figure 5-9), define
the parameter configuration which is appropriate for the
point. A status line provides helpful information to aid your
selections. Press OK to continue or Cancel to abort.
7. The Point Help page appears, displaying updated
information about the point.
SiteScan 2000 for Windows User’s Guide
Advanced Topics • 5-17