Download User Manual

Transcript
Brushless Motor Introduction
Sensor outputs are generally Open Collector, meaning that they require a pull up resistor in
order to create the logic level 1. Pull up resistor of 4.7K ohm to +5V are incorporated inside
all controllers. Additionally, 1nF capacitors to ground are present at the controller's input in
order to remove high frequency spikes which may be induced by the switching at the
motor wires. The controller's input buffers are Schmitt triggers to ensure a clean transition
between high and low.
+5V Out
4.7K
Input
Buffer
HA, HB, HC
1nF
GND
FIGURE 40. Hall sensor inputs equivalent circuit
Hall sensors can typically be powered over a wide voltage range. The controller supplies 5V
for powering the Hall sensors.
Hall sensor connection to the controller is done using Molex Microfit 3.0 connectors.
These high quality connectors provide a reliable connection and include a lock tab for
secure operation. The connector pinout is shown in the controller model's datasheet.
Important Warning
Keep the Hall sensor wires away from the motor wires. High power PWM switching
on the motor leads will induce spikes on the Hall sensor wires if located too close.
On hub motors where the Hall sensor wires are inside the same cable as the motor
power wires, separate the two sets of wires the nearest from the motor as possible.
Important Notice
Make sure that the motor sensors have a digital output with the signal either at 0 or
at 1, as usually is the case. Sensors that output a slow changing analog signals will
cause the motor to run imperfectly.
Hall Sensor Wiring Order
The order of the Hall sensors and these of the motor connections must match in order for
the motor to spin. Unfortunately, there is no standard naming and ordering convention for
brushless motors. It often is the case that the motor will correctly operate when wiring the
controller's sensor inputs HA, HB, HC, and the controller's U, V, W outputs in the same
order as what is marked the motor or leads (if such an order is provided).
Advanced Digital Motor Controllers User Manual
69