Download Programming manual ATV66

Total unlock : drive initialization
Drive initialization
Select Drive initialization mode in the Main menu.
ENT
ESC
9‘DRIVE INIT.
TOTAL FACTORY SETT.
PARTIAL FACT. SETT.
USER SETTING STORE
RECALL USER SETTING
When this mode is used, the motor must be stationary.
This mode is used to return to factory settings :
– either totally,
– or partially.
It can also be used to download the configuration and all
the settings remotely onto a blank PCMCIA card which
can be installed on the speed controller.
Conversely, after a PCMCIA card to which data has been remotely downloaded has been installed,
this mode is used to transfer data to the speed controller.
Return to factory settings
Total return
9.1‘TOT.FACTORY SETT
Do you want to change
all the parameters
to factory settings?
ENT to confirm
ESC to abort
THIS ACTION CLEAR THE
ACTUAL CONFIGURATION
AND SETTINGS
ENT
Are you sure ?
ENT to confirm
Warning message
Partial return
9.2‘PARTIAL FACTORY
DISPLAY CONFIG.
KEYPAD CONFIG.
GENERAL CONFIG.
Select the block to
be initialized ‘ ENT
THIS ACTION CLEAR THE
ACTUAL CONFIGURATION
AND SETTINGS
OF :
Are you sure ?
ENT to confirm
ENT
Select the required mode to be
reset to factory settings.
Warning message with indication
of the mode selected
Comment : a total return to factory settings returns the speed controller to its initial state before
the first power-up (see pages 4 and 8).
67