Download Be2K-Plus USER Manual

Transcript
Be2K-PLUS
User's Manual
V200
-
March -
010
page 4
Section: 1.0 Introduction
The Be2K-Plus integrates a 3-Phase Automatic Mains Failure module and a Generating Set controller. The Be2K-Plus
provides visual indication by means of LEDs and Displays for Engine environment, Electrical parameters and Alarms. The
Be2K-Plus is pre-programmed by your Panel or Genset manufacturer. Figure 1 illustrates the layout of the front panel.
Figure 1: Front Panel layout
Low Oil
Pressure
shutdown
5 x Red
LEDs
4-digits
LED
Display
Current
Mode
HighEngine
Temperature
shutdown
No fuel in
the Tank
shutdown
Emergency
Alternator
Alarm or
(Generator)
shutdown J1939/Red lamp
Warning Alarm
or J1939
Amber lamp
F1
F1
V1
Yellow
LED
A1
F1
V2
A2
V3
A3
128X64
Graphic
Display
F2
F4
F3
F5
TEST
AUTO
Voltage
Mode
TEST
F6
Engine
Running
green LED
Engine
start
pushbutton
Engine stop
pushbutton
START
STOP
Generator Vac
& Contactor
status indicators
Pushbutton
to open
Contactors
Contactor of
the Mains
pushbutton
Pushbuttons
for the control
of the LCD
Display
AUTO or TEST
pushbutton
(green LED)
Contactor
of the MAINS
green LED
OFF
MAINS
Voltage
green LED
MANUAL mode
pushbutton
with Green LED
Engine stop,
OFF mode
selection
pushbutton
MAN
Contactor of
the Generator
pushbutton
[ACK-F1]
Alarm
acknowledge,
horn silence &
Volt / Ampere
selection
pushbutton
Section 2.0: Selecting an Operational Mode
The mode of operation is selected by pushbuttons and indicated by means of green LEDs:
NOTE: If the BE2K-PLUS was in TEST or
AUTO prior to power down (battery supply),
when you switch on the power supply, the
Be2K-Plus enters the AUTO mode. In all
other cases, the Be2K-Plus will enter the OFF
mode.
The following sections describe the modes
of operation.
4