Transcript
PHXG-91B PHWX-81B PHWU-81B Congratulations on purchasing this product Quick Setup Guide Packaging Contents 1 (EU/US/CH) user manual AAA (2x) Side Cover Removal 2 Loosen the four captive screws on each of the two side panels. Direction to release the side covers from the unit. Lens Assembly 3 Please consult the full User Manual for detailed info on Lens Assembly or Lens Replacement. This should only be done by a qualified Service Technician, preferrably prior to ceiling mounting. Rear Cover 4 Loosen the 4 screws at the back and remove the rear cover to gain access to the inputs panel. Ceiling Mount* 5 240 120 192 M4x10mm MAX. (4x) (283) Unit Weight: 21 kg Please check the manual of your supportsystem for compatibility 171 *(Ceiling mount system is not included) 342 Input Cables 6 (See User Manual for detailed info on Inputs and PiP) Remote Control 7 Quick Keys Feedback LED Menu - UP Menu - RIGHT Menu - DOWN Menu - OK Menu - LEFT (for Remote and keypad) Quick Key 1 Push Menu-UP twice for instant ‘Picture Mute’ Quick Key 2 Home/Menu Power On/Off Push Menu-OK for quick access to the Focus/Zoom Menu Battery Lid (Slide down to open) Starting Projector 8 IR Position Front OFF/STBY IR Position Rear 1 sec 1 sec 1 sec 1 sec 1 sec ON Error During Start-up Status Led OSD Lite Menu 9 INPUT BRIGHTNESS ASPECT RATIO LENS FOCUS KEYSTONE LANGUAGE CONTRAST LENS ZOOM COLOR LENS SHIFT i M INFO MODE i SERVICE ADVANCED 10 INPUT BRIGHTNESS CONTRAST COLOR ASPECT RATIO LENS FOCUS LENS ZOOM LENS SHIFT KEYSTONE LANGUAGE INFO MODE SERVICE ADVANCED Toggle between input sources adjust lamp brightness level adjust image contrast adjust image colour modify image aspect ratio adjust lens focus adjust lens zoom adjust lens shift adjust keystone select language information on lamp status normal/eco/power service information see user manual Important Info For more information and Maintenance Guidelines, check the Detailed User Manual on: http://www.barco.com/en/products-solutions/projectors R5905603-00 MAN QSG PH-series - To save lamp lifetime, first switch the projector to standby mode and wait two minutes, then switch off the main power. - Ensure that the projector is operating with clean filters. - Do not block the ventilation in -and outlets. - Using the projector at a non recommended tilt angle will reduce the lifetime of the lamps or create unexpected behaviour of the unit. - Laser light can cause severe damage to the DMD. This damage is not covered by warranty.