Download JetNet 4008f

Transcript
Coupling Port is responsible for data backup path recovery between two separate redundant
Rings, and Control Port is for communicating control signal between “Coupler” switches.
Note: The Super Ring Redundant ports, Coupling port and Coupling Control port must all be
assigned to different ports.
Enable Couple Ring
Setting
Enable/ Disable
Description
Factory Default
Select the JetNet as “Coupler”
None
Setting
Description
Factory Default
Coupling Port
Select any port of JetNet to be
Port 3 is enabled for Couple
the “Coupling Port”
Ring
Select any port of JetNet to be
Port 4 is enabled for Couple
the “Control Port”
Ring
Coupling Ports
Control Port
Network Redundancy: Dual Homing
Dual Homing provides an advanced redundancy network solution by connecting switches
running in different redundant protocols (e.g. IEEE 802.1w Rapid Spanning Tree Protocol and
Super Ring) to extend the network redundant coverage.
Technology Overview
Redundancy is achieved by connecting two ports from two separate switches using Super Ring
protocol with two ports of Managed Switches using RSTP protocol (please see connection in
Figure-DualHoming). An active link where data is transmitted is connected with one port in the
switch. The other port connected with another switch is a hot standby link. Constantly monitoring
the hot standby link and will switch over in seconds once the active link is disconnected or breaks.
3-24 Korenix JetNet 4500 Series Industrial Managed Ethernet Rail Switch User’s Manual