Download Ipso Facto Issue 18
Transcript
PAGE: 42 different low byte values in RE. Check that the control signals used on the board (MRD,MWR,AO,A1) all appear correctly. Since there are no data buss buffers on this board, no further checks of the buss interface are necessary. • B-I/O Port Checks Install IC5 on the board. Using the program in Listing 2, exercise the I/O Port. Check that all 24 lines (mapped as outputs for this test) appear as both a 0 and a 1. If a problem appears, then modify the test routine to exercise only the bad lines and their adjacent pins and PCB runs in different ways. The problem is most likely an open or shorted connection on the PCB and can be quickly tracked down by observing the pattern of the errors produced. Be sure also the test the I/O lines right at the point where the IC pins go into the IC package, as well as on the associated PCB connections. If IC6 is to be used, install it now and repeat the above test. Be sure to add 4 to the low byte of all I/O addresses used in Listing 2, so as to address the correct IC. Listing 1- Address Decoding and Read Check: LOOP1: LDI PHI LDI PLO LDN BR OFF RE 1100 RE RE LOOP1 ;SETUP RE TO POINT TO MEMORY-MAPPED I/O PAGE, AND ANALOG OUTPUT BOARD • ;READ THE BOARD REPEATEDLY Listing 2- 8255 I/O Port Output Test LOOP2 LDI PH I LDI PLO LDI STR LDI PLO LDI STR DEC STR DEC STR LDI PLO LDI STR IIFF RA 1103 RA 1180 RA 1102 ;SETUP RA TO POINT TO MEMORY-MAPPED , I/O PAGE AND ANALOG OUTPUT BOARD, , I/O PORT CONTROL BYTE ;INIT.' I/O PORT AS ALL OUTPUTS ;POINT TO PORT C RA IIFF RA RA RA RA RA /102 RA 1100 RA ;STORE FF INTO PORT C, PORT B, , AND PORT A. ;POINT TO PORT C AGAIN ;STORE 00 INTO PORT C, •