Download TDC-V4 - lumat

Transcript
3.f. Acknowledgment Modes
Possibilities of Event Acknowledgment according to the suitable Acquisition Mode for
the experiment are presented on the following table :
Acquisition
Mode
Acknowledgment
Mode
EBE_HOST_ACK
EBE_EXT_END
Event by Event
EBE_TDC_AUTO
Accumulation
ACC_TDC_AUTO
TDC-V4 supplies to the acquisition software
processor only the data relative to one Event and
enables a new Trigger after it is acknowledged by
the acquisition software by means of the
command HOST_ACK.
TDC-V4 supplies to the acquisition software only
the data relative to one Event and enables a new
Trigger after it is acknowledged by means of the
command EXTERNAL_END.
TDC-V4 supplies to the acquisition software only
the data relative to one Event and enables a new
Trigger as soon as all the data relative to this Event
are stored into FIFO-ACQ output buffers. This
Acknowledgment Mode involves that the user
controls the Trigger signal in order to ensure the
correlation of all data sources making up the Event.
TDC-V4 piles up in succession into FIFO-ACQ
output buffer the data related to the successive
Events. Each Event is acknowledged automatically
as soon as all the data relative to an Event are
stored into FIFO-ACQ output buffers.
Acknowledgment Mode selection is controlled by the following register :
name
ACK_MODE
PCI
address
260 0000h
TDC-V4 – User Manual
data
21
0
0
1
1
20
0
1
0
1
mode
ACC_TDC_AUTO
EBE_TDC_AUTO
EBE_EXT_END (optional)
EBE_HOST_ACK
20