1
Download User Manual
Transcript
XTR-8LR100 --------------------------------------------------------------------------------------------------------------------------------------------------- User Manual S6 r/w S7 r/w S8 r/w (note 3) S10 r/w S11 r/w S12 r/w S20 r/w S30 r/w S90 r S91 r/w S92 r/w Error recovery 1 = 4/5 (default) 2 = 4/6 3 = 4/7 4 = 4/8 Adds in rear of payload the RRSI 0 = No RSSI (default) RSSI value (2 bytes) 1 = RSSI in coda al payload ENABLE UART data rate 0 = 9.600 bps UART BPS 1 = 19.200 bps 2 = 115.200 bps (default) 0 = No network(default) Adds on top of payload, the ID NETWORK 1 = network network and Source address ENABLE It sets the device network address (4 Min = 0x00000001 (default) NETWORK bytes) Max = 0xFFFFFFFF ID It sets the device ID or sender (2 Min = 0x0001 (default) SOURCE bytes)start address message Max = 0xFFFF (broadcast) ADDRESS RX CYCLIC It sets the wake up time interval from Min = 10 ms 2 cyclic receptions from 10ms to Max = 6.000 ms TIME 6000ms with steps of 1ms Default = 100 ms (default) It sets the wake up time interval from Min = 1 s ADC 2 cyclic trasmissions Impostazione Max = 65.535 s TX TIME dell’intervallo di risveglio tra 2 Default = 10 s trasmissioni cicliche from 1s to 65536s with steps of 1s. Addressing is activated by default S1 = x (x = value restored) REGISTERS Registers value restores S2 = x STATUS S3 = x …. Sn = x Setted at 1 it stores on register, the 0 = Modified values (r) DEFAULT default values 1 = Default values (r/w) VALUES Ping-Pong radio test mode 0 = Off RADIO 1 = On Tx Master TEST_MODE 2 = On Rx Slave ERROR CODING (note 1) NI means not implemented yet. Command execution doesn't have any effect. (note 2) To apply with limits imposed by EN300 220 normative, channeling is viable only with BW 20,8 KHz; for the others BW (62,5 KHz e 125 KHz) setting of channel is useless and module will work only on default channel (note 3) UART data rate setting (command S8), refers exclusively to data communication. In command mode this setting has no effect and it will work onlt at 9600 bps. Command Name WR WRITE Feature Write registers value to EEPROM CC COMMAND CLOSE Command Mode exit Sx REGISTER NAME Register ID to be read or write Le caratteristiche tecniche possono subire variazioni senza preavviso. AUR°EL S.p.A. non si assume la responsabilità di danni causati dall’uso improprio del dispositivo. ------------------------------------------------------------------------------------------------------------------------------------------------------------------AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY Rev 2.0 11/03/2015 Pag 10 di 20 Tel.: +39.0546.941124 Fax: +39.0546.941660 http://www.aurelwireless.com - email: [email protected]
