Download OPERATING INSTRUCTION MANUAL MODEL

Transcript
• Alarm Relay Low
4.8 DIP Switches
4.8.1
The controls which are frequently used in the normal operation of the instrument are
all accessible on the control panel. Some switches, which are infrequently used are
located on the back of the swing-out board.
4.8.2
The DIP switches are scanned on RESET, power-up and every time the instrument
is taken into the menu mode. Therefore, after changes to the DIP switch settings,
you must take the unit offline by pressing CALL in order for the instrument to scan
the new DIP switch values.
4.8.3
The following table describes the use of the 16 DIP switches:
DIP Switch
Bank S1
1
2
3
4
5
6
7
8
Description of Use
Selects temperature unit
Enables use of Password Feature
Fail Safe mode for Relay A
(for Model 2200D-X-2 only)
Direction of Control Relay A
(for Model 2200D-X-2 only)
Alarm Relay to Activate for Memory Loss
Fail Safe mode for Alarm Relay
Auto Return from menu if no button pressed
0-5 Vdc / 0-1 mA selector
Switch
OFF
Switch
ON
°F
YES
NO
°C
NO
YES
Rising
Falling
YES
NO
NO
Temperature
NO
YES
YES
D.O.
NO
Rising
YES
Falling
Dip Switch
Bank S2
1
2
3
4
5
6
7
8
Model 2200D/P91
Fail-safe for Relay B
Direction of Control for Relay B
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Page 11