Download User manual

LEDdiagnostics DPC-49-ADU
4.7
LEDdiagnostics DPC-49-ADU
Table 5:
LED-diagnostics
LED
Behavior
Function
Run
Off
The module has no power supply.
Green
The module's power supply is ok.
Green blinking
The connection of the internal diagnostic bus is
established.
Red
The power supply voltage is insufficient.
Off
No alarm exists.
Yellow
A pre-alarm exists for H1-segments S1 to S4.
Red
An alarm exists for the H1-segments S1 to S4.
S1 to S4
4.8
Software installation for start-up the DPC system
The required software for the startup of the DPC-system can be found on the internet page:
www.turck.com
Download the following software-data files to your PC:
 „PACTwareTM 3.6" - PACTwareTM is a manufacturer and fieldbus independent software for operating
field devices. It represents a FDT-frame application in which the single components of a
communication architecture and the interfaces are represented as DTM.
 "Microsoft®. Net framework 1.1" - Microsoft® Programming platform .NET Framework
 "Service Pack 1 for Microsoft®.Net framework 1.1" - service pack for Microsoft®-programming
platform .NET Framework
 "DTM DPC-System V1.10" - DTM for TURCK DPC-system.
 "DTM FF_HSE/COM V1.04" - Communication-DTM between PC-network card and HSE (High Speed
Ethernet) FOUNDATIONTM fieldbus. The data file FFdtmG_.. is available for a German operating
system, and the data file FFdtmE_.. is available for an English operating system.
Download the software to your PC and unzip the received Zip-file. Install the Microsoft®-software and
afterward the TURCK-software as described in the follwing paragraphs.
D301167 0212 - FF-Diagnostic-Power-Conditioner-System
4-9