Download User manual

Startup with PACTwareTM
4.10.3
Parameters
With the function Parameterization/Online Parameterization you may determine the population of the
module carrier and which H1segments and limit values should be monitored. For each H1-segment you
may select which values are to be measured and set the limit values for an alarm. All values are
measured by default and limit values are preset.
The DTM of the DPC-49-HSEFD/24VDC offers the selection "Parameterization" or "Online
Parameterization".
With the function "Parameterization" you may set the parameters of your project without online
connection to your DPC-49-HSEFD/24VDC. By opening the function, the parameters are set based on
their prior storage in the project. The default parameters are displayed for new projects. The changed
data may be stored in the project.
The function "Online Parameterization" is only available when the online-connection to the DPC-49HSEFD/24VDC is established. By opening the function the parameters are displayed based on their
prior storage in the device. The changed data can be directly transferred to the device.
Parameterization
With the menu option "Parameterization" the configuration of the DPC-system and the setting of the
limit values for the alarm can be defined offline.
Note
Save the changed data by using the save function of the software "PACTwareTM" (
unsaved changes will be lost!
),
Figure 24:
"Parameterization"
D301167 0212 - FF-Diagnostic-Power-Conditioner-System
4-19