Download MINI AVSS

DHS Systems, LLC
TM 95236-00
0005
Position and Set-up of the AVCS (MINI)
CAUTION
The AVCS (MINI) transit caser is a two person lift.
1. Lay the AVCS (MINI) transit case on its back.
2. Turn all twist locks three-quarters turn to release the front cover (Figure 2, Item 1) from AVCS (MINI) transit case
and remove from the main case (Figure 2, Item 2).
1
2
3
Figure 2. AVCS (MINI) Transit Case with Twist Locks.
3. Lift the AVCS (MINI) transit case into a standing position.
NOTE
The position of the AVCS (MINI) is determined by the components being connected to it. The control
panel cable is 25’ in length. Position the case so all components can be connected without cables
interfering with traffic through the operations center.
4. Move the AVCS (MINI) into its setup location.
5. Release the twist locks on the rear cover (Figure 2, Item 3) and remove from the main case.
6. Realign all twist locks and press down on the clasps to flatten locks against the case.
7. Locate the power cable for the AVCS (MINI) in the ancillary equipment case.
NOTE
Do not connect the power supply to an active power source until the ground has been properly
established and all accessory devices have been attached to the AVCS (MINI) main body.
8. Lift the rubber dust cover off of the power connector, located on the bottom right side of the rear of the AVCS
(MINI), and insert the female end of the power cable into it. Do not connect the power source at this time.
0005-3
No rights are conveyed except as indicated in the legend on the cover of this document.