1
Download "user manual"
Transcript
Cycles 9.6 Error Messages and Error Handling Table 9-22 Alarm Number Alarm Text Source Explanation, Remedy 61000 ”No tool compensation ac- CYCLE93 tive” to CYCLE95 D offset must be programmed prior to cycle call 61001 ”Illegal thread pitch” CYCLE84 CYCLE840 CYCLE97 Check parameters for thread size or pitch specification (are contradicting) 61002 ”Machining type defined incorrectly” CYCLE93 CYCLE95 CYCLE97 The value of parameters VARI for the machining type is specified incorrectly and must be changed 61101 ”Reference plane defined incorrectly” CYCLE82 to CYCLE88 CYCLE840 Either different values for reference and retraction plane must be selected in the case of relative specification of the depth or an absolute value must be specified for the depth. 61102 ”No spindle direction programmed” CYCLE88 CYCLE840 Parameter SDIR (or SDR in CYCLE840) must be programmed 61107 ”First drilling depth defined incorrectly” CYCLE83 First drilling depth is opposite to total drilling depth 61601 ”Finished part diameter too small” CYCLE94 No finished part diameter was programmed. 61602 ”Too width defined incorrectly” CYCLE93 Cutting tool is larger than programmed groove width 61603 ”Groove form defined incorrectly“ CYCLE93 S Radii/chamfers at groove base do not match with groove width S Face groove at a contour element running parallel to the longitudinal axis is not possible. 61604 ”Active tool violates programmed contour” CYCLE95 Contour violation in relief cut elements due to the clearance angle of the tool used, i.e. use a different tool or check the contour subroutine. 61605 ”Contour programmed incorrectly” CYCLE95 Illegal relief cut element detected 61606 ”Error in contour preparation” CYCLE95 An error has been found in the contour preparation; this alarm always occurs in conjunction with an NCK alarm 10930 ... 10934, 15800 or 15810 61607 ”Starting point programmed incorrectly” CYCLE95 The starting point reached prior to the cycle call is not outside the rectangle described by the contour subroutine. 61608 ”Invalid tool point direction programmed” CYCLE94 A tool point direction 1...4 matching to the relief cut form must be programmed. 61609 ”Form defined incorrectly” CYCLE94 Check the parameters for the relief cut form. 61611 “No intersection point found“ CYCLE95 No intersection point with the contour could be calculated. Check the contour programming or change the infeed depth. 9-322 SINUMERIK 802D, 802D base line 6FC5 698 - 2AA00- 0BP3 (11.03) (OP - T)
