1
Download "user manual"
Transcript
Part Programming 6.2 Editing a Part Program - Operating Mode ”Program” Operating sequence Use the ”Program manager” to select the program you want to edit and select Open to open the program. Softkeys Edit Execute Mark block Copy block Program editor Pressing this key will execute the selected file. Use this softkey to select a text block up to the current cursor position. Use this softkey to copy a selected block into the clipboard. Insert block Use this function to paste a text from the clipboard to the current cursor position. Delete block Use this softkey to delete a selected text block. Find Use the softkeys Find and Find Next to search for a string in the displayed program file. In the input box, type the term you are looking for and press OK to start the search. If the string you are looking for is not found in the program file, an error message appears. Use Back to close the dialog box without starting the search. Renumber Contour Drill Milling Turning Recompile Simulation 6-76 This function replaces the block numbers from the current cursor position to the program end. For programming the contour (”blueprint programming”), see Section 6.3. see Manual ”Cycles” see Manual ”Cycles” (with the options ”Transmit” and ”Tracyl”) see Manual ”Cycles” For recompilation, position the cursor on the cycle calling line in the program. The function decodes the cycle name and prepares the screen form with the appropriate parameters. If there are any parameters across the valid range, the function will automatically load default values. If the screen form has been quitted, the original parameter block is replaced by the corrected block. Please note: Only blocks generated automatically can be recompiled. The simulation is described in Section 6.4. SINUMERIK 802D, 802D base line 6FC5 698-2AA00-0BP3 (11.03) (OP-T)
